Month: June 2017

Laminate Trouble Shooting Guide

Problem Solution Wrinkling of the plastic on a laminated piece of material. Make sure you have enough supply roll tension to take  the wrinkles our of film before it gets past the heat roller. Film is not properly adhered or starts to come off sometime after lamination. Unless there is something wrong with the film this problem comes from film being run at too low a temperature. Check the heat setting on the laminator. If the film is not sticking to the item it is likely that more heat is required. If you are running thicker films you may...

Read More
  • 1
  • 2

Visit our FAQ center

Hello! My name is Owlbert Einstein, the Print Finishing Expert at Nobelus. The Nobelus University is my library of knowledge about products, applications, markets, and special insights.

Also, just for you, I offer a continually growing public FAQ’s center where you can find answers to many print related questions, and if you can't, you can ask me, and I'll do my best to get you one.


ASK OWLBERT AT THE FAQ CENTER NOW!